One-Step Colour Intensifier & Impregnator

Universeal Colour Plus is a solvent based colour enhancer and impregnator that penetrates into the surface of the stone to protect against oil and water based stains. Universeal Colour Plus can be applied to grout, tumbled marble, limestone, slate, quarry tiles, sandstone & most types of masonry surfaces.

This product is UV resistant and does not yellow. Not recommended for use on highly polished, glazed/ceramic and non-porous surfaces. Colour Plus can be applied 24hrs after installation process. [Data Sheet]

Special Features

• Enhances natural colour & texture
• For use on all types of natural stone surfaces
• Prevents staining from water, dirt & oil
• Suitable for internal & external use
• 20 year protection

Packaging Options:

• 1 Litre tins with childproof cap (12 per carton)
• 5 Litre tins with childproof cap (4 per carton)

Coverage:

Up to 20m2 per litre dependant on porosity of surface. Check the surface after application to ensure full effectiveness of impregnator. Apply a second or third coat if necessary.

Directions for use:

Important: Universeal Colour Plus Intensifier is very difficult to remove once hardened. Therefore, please read instructions carefully.

The surface to be treated must be completely clean, dry and free from contamination e.g. old topical sealer or polish. If necessary, first clean floor with Universeal Extreme Clean and allow to dry thoroughly. Apply Universeal Colour Plus thinly and uniformly with a cloth, brush, sponge or roller and allow to penetrate for approximately 15-20 minutes before wiping over with a clean dry fluff-free cloth to remove any excess which may remain on the surface. N.B. The surface must retain a matt finish after treatment. Any excess left on the surface could oxidise to form an unsightly gloss varnish. For stronger colour enhancement, also in the case of more absorbent surfaces, further coats may need to be applied.

Allow at least 45-60 minutes from application of previous coat before applying further coat. N.B. The aim is to completely fill the substrate with Colour Intensifier without over applying it or allowing any excess to oxidise on the surface of the tiles.

Do not apply in direct sunlight or in a temperature exceeding 25 degrees centigrade.

Beware of application upon floors with under floor heating as the product may dry prematurely. For further enhancement and to provide a shine finish, Universeal Gloss & Seal can be applied. If you are unsure of correct application methods, test on an inconspicuous area, prior to general application.

Usage Guidelines:

Technical Information
and Application Guide

Download (PDF, 741kb)